HP StoreEver MSL2024 User And Service Manual page 136

Depending on other devices attached to the same parallel SCSI bus and their SCSI
IDs, you might need to change the SCSI ID before using the device. Review the manuals
for the other devices on the parallel SCSI bus or your operating system to determine
which SCSI IDs are currently in use. Change the SCSI ID with the OCP (for the MSL2024
see
(page
configuration (Configuration > Drives)" (page
configuration" (page
◦
Verify that all parallel SCSI cables are securely connected on both ends. Check the
length and integrity of your parallel SCSI cabling. Check the parallel SCSI connector
136 Troubleshooting
Figure 79 MSL8048 and MSL8096 parallel SCSI tape drive default SCSI
addresses
1. Tape drives with SCSI address 4
"Changing the SCSI address — parallel SCSI drives (Configuration> Change Drive)"
98), for the MSL4048, MSL8048, and MSL8096 see
72)).
"Changing the drive
123)) or RMI (see "Changing the drive