Regulatory specifications
Table 50 CSA test conditions
Characteristic
Equipment mobility
Connection to the mains
Operating condition
Access location
Over voltage category (OVC)
Mains supply tolerance (%) or absolute
mains supply values
Tested for IT power systems
IT testing, phase-phase voltage (V)
Class of equipment
Considered current rating (A)
Pollution degree (PD)
IP protection class
Altitude during operation (m)
Altitude of test laboratory (m)
Mass of equipment (kg)
Manufacturer's Declared Ambient (°C)
NOTE:
The CSA test conditions might differ from the product specification limits.
Default and restore defaults settings
You can save the library configuration settings to a file, restore the settings, or reset the library
configuration to the default settings.
parameters, with their default settings and whether they are reset to default or saved to a file.
Table 51 Default settings
Parameter
Tape drive settings
SCSI drive
address
FC drive
configuration
Tested condition or value
Stationary (rack-mount or desk-top)
Pluggable — Type A
Continuous
Operator accessible
OVC II
-10%, +6%
No
N/A
Class I
20 A (branch circuit protection)
PD 2
IPX0
Max 2000
38
Max 25 kg
40 °C
"Default settings" (page 207)
Default setting
MSL2024: A full-height tape drive
has SCSI ID 4. The bottom
half-height tape drive has SCSI ID 4
and the top drive has SCSI ID 5.
MSL4048: All full-height tape drives
have SCSI ID 4. Half-height drive
slots have SCSI ID of 4, 5, 4, 5 from
the bottom up.
MSL8048 and MSL8096: All tape
drives have SCSI ID 4.
Automatic speed, auto port type
lists the library configuration
Reset by Set Defaults
Yes
Yes
Regulatory specifications 207
Stored in Saved Config
file
Yes
Yes