HP StoreEver MSL2024 User And Service Manual page 176

Table 40 Warning event codes (continued)
Event code
49
4A
4B
4C
4D
4E
4F
50
51
52
53
55
56
57
176 Troubleshooting
Description
SCSI: incompatible magazine, magazine not
accessible
Source not ready
Destination not ready
Reservation failed
Library controller busy
Invalid robotic request
Robotic not initialized
Cartridge location in a different partition; move
across partition boundaries was initiated.
Incompatible medium
All slots full; no movement possible
Wellness test: invalid test setup
Invalid license key
No decryption key available on token
Key server token PIN required
Details and Solution
an HPE MSL-G3 or 1/8 G2 firmware revision. If
firmware is not the correct type, the wrong tape
drive has been installed. Use only Hewlett
Packard Enterprise-approved support to insure
that the correct tape drives are used.
Verify that a supported magazine for that slot is
inserted. If the magazine is in the lower left
position, verify that the type of magazine is
consistent with the mailslot configuration.
Retry the operation.
Check the status of extended libraries.
Retry the operation.
Check the status of extended libraries.
The application software made an illegal request.
Retry the operation.
The library will not move a cartridge from one
logical library to another logical library.
To move a cartridge from one logical library to
another:
1. Move the cartridge to the mailslot.
2. Remove the cartridge from the mailslot.
3. Close the mailslot.
4. Replace the cartridge in the mailslot.
5. Move the cartridge to a slot in the new logical
library.
Verify that the drives are installed correctly.
Verify that the cartridge and tape drive
generation are compatible. See
read compatibility" (page
Verify that the tape is correct for the operation
initiated.
Remove a cartridge from the device to make a
slot available for the move operation.
Load tapes in the four top-level corner slots.
See"The wellness test" (page
Verify that the correct license key was entered.
Verify that the Caps Lock key is not
depressed. The key is case sensitive.
Ensure that the key server token containing the
key used to encrypt the tape is installed in the
USB port.
Use the RMI to enter the PIN for the key server
token that is installed in the USB port.
"Backward
45).
146).