HP StoreEver MSL2024 User And Service Manual page 125

Figure 75 MSL4048 parallel SCSI tape drive default SCSI addresses
1. Tape drives with SCSI address 4
2. Tape drives with SCSI address 5
◦
MSL8048 and MSL8096: The default SCSI address for all tape drives is 4.
The library will no longer recall drives that have been removed.
Fibre Channel drive configuration: Automatic speed, auto port type
Master drive: reset to Drive 1 or the lowest numbered existing drive
Drive power: all drives powered on
Active slots: maximum possible
Library mode: Automatic
Event log levels and filter: continuous trace and all levels and filters active (for Service use
only)
Barcode reader label length: 8
Barcode reader alignment: Left
Ignore barcode media ID: Disabled
Admin password required for magazine access: Enabled
All types of failover: Disabled
Encryption: Disabled
NOTE: Defaults will not be reset if encryption is enabled.
HTTPS: Disabled
Restricted Network Access: Enabled
Error recovery: On
Mailslot configuration: mailslot disabled
Auto clean: disabled
SNMP: disabled, but saved addresses do not change
E-mail notification: disabled, but configurations retained
License keys
The following settings are not reset:
Using the MSL4048, MSL8048, and MSL8096 OCP 125