HP StoreEver MSL2024 User And Service Manual page 187

Hide thumbs Also See for StoreEver MSL2024:
Table of Contents

Advertisement

2.
Holding the tape drive by the handle and supporting it from the bottom, slide it into the drive
bay until it is flush with the back of the library (see
Figure 91 Installing a new tape drive
3.
Tighten the blue captive screws (see
to the library chassis.
Figure 92 Tighten the blue thumbscrews
4.
Plan the configuration for the new tape drive:
FC: See
"Planning the Fibre Channel configuration" (page
SAS: See
"Planning the SAS configuration" (page
Parallel SCSI: See
address must be changed, do so before connecting the drive to the host. See
the SCSI address (parallel SCSI only)" (page
5.
Connect the tape drive to the host:
FC: Plug one end of the FC cable into a port on the tape drive. Plug the other end of
the cable into the HBA or switch.
SAS: The cable recommended for use with the SAS library can connect up to four SAS
tape drives to an HBA. Any tape drive can be connected with any of the four tape drive
ends of the cable. Plug one of the unused mini-SAS connectors on the tape drive end
of the cable into the connector on the tape drive.
Parallel SCSI: Connect one of the connectors on the parallel SCSI cable to the tape
drive and connect the other end of the cable to the HBA or other device on the same
Figure 92 (page
"Planning the SCSI configuration" (page
Figure 91 (page
187)).
187)) by hand to secure the tape drive
22).
23).
25). If the tape drive's SCSI
36).
Installing a new tape drive 187
"Changing

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storeever msl4048Storeever msl8048Storeever msl8096

Table of Contents