Hardware packets containing M6 screws.
Select the hardware packet for your rack
7.1 mm Round-Hole Rack
9.5 mm Square-Hole Rack
Install the rails
Using the screws from the packet for your rack and a #3 Phillips screwdriver, secure the
front of one rail to the front of the rack. The support platform of each rail is tapered, narrowing
towards the rear.
Extend the rail to the depth of the rack and secure the rail to the back of the rack.
Repeat steps 1 and 2 to install the other rail.
HPE supported racks with 7.1 mm round holes in the rack column
HPE supported racks with 9.5 mm square holes in the rack column
Installing the library in a rack