Download  Print this page

Advertisement

Table 40 Warning event codes (continued)
Event code
65
66
67
70
71
72
73
74
75
76
77
78
7B
80
81
82
83
84
178 Troubleshooting
Description
Invalid upgrade cartridge. Drive has rejected the
cartridge as invalid.
Diagnostic tape write protect.
Incompatible medium
SCSI message error
SCSI parity error
SCSI invalid message
SCSI: overlapped command attempt
SCSI: echo buffer overwritten
Download prevented — barcode reader
hardware requires newer code revision.
Destination element unexpectedly full.
Download prevented because of an incompatible
library controller.
Download prevented because of incompatible
robot firmware.
Invalid firmware version. Only signed firmware
images are allowed.
Movement retry. Robotics movement did not
succeed but was successful on a retry.
Drive sled fan alert. Fan motion has stopped.
Clean request from the tape drive
Media attention
Tape drive tape alert; tape drive reported a
warning or critical tape alert.
Details and Solution
Retry the operation.
If problems persist, exchange the data
cartridge.
The diagnostic test needs to write data but the
tape being used for the test is write protected.
Ensure that the device has a tape that is not write
protected for use during the diagnostic test.
The drive tried to read or write data from a tape
from an incompatible LTO generation. For
compatibility information see
compatibility" (page
45).
Check the SCSI cable connection and verify that
the maximum cable length is not exceeded. Verify
that the SCSI bus is properly terminated.
The application software made an illegal request.
Update the library to the most current firmware
version.
This can happen if a cartridge is moved without
the library completing a full inventory. Rescan the
tapes from the RMI or OCP.
Update the library to the most current firmware
version.
Update thelibrary to the most current firmware
version.
The library will only accept signed firmware
images. Download a signed firmware image.
Recovered error move operation. No action
required. Occasional retries are normal operation.
Check the tape drive fan on the library back
panel to see whether the fan is operational
and not obstructed.
NOTE:
The sub-error code indicates the
affected tape drive. For example, 00 is drive 1
and 01 is drive 2.
NOTE:
Fan only operates when cooling is
required.
Clean the indicated tape drive using a valid
cleaning tape.
NOTE:
The sub-error code indicates the
affected tape drive. For example, 00 is drive 1
and 01 is drive 2.
Evaluate media status using L&TT.
Evaluate drive status using L&TT.
"Backward read

Advertisement

   Also See for HP StoreEver MSL2024

   Related Manuals for HP StoreEver MSL2024

Comments to this Manuals

Symbols: 0
Latest comments: