Other Errors - Fuji Xerox apeosport-IV 7080 Administrator's Manual

15 Problem Solving
Error Code
133-710
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.

Other Errors

This section describes the remedies when the following messages are displayed.
Error
Message
A fault has occurred.
Switch off the machine.
(xxx-yyy)
Completed with an error.
(xxx-yyy)
A fault has occurred. The
machine has rebooted.
Select [Close]. If the
problem persists, call for
service.
(xxx-yyy)
15
532
[Cause] When printing the received fax document, the paper loaded in the
bypass tray was used for printing because the specified tray could not
be used.
[Remedy] Take one of the following measures:
Load paper available for printing the received fax document:
A3 SEF , A4 LEF , B4 SEF , B5 LEF ,
A4 SEF , A5 SEF , B5 SEF , 8.5 x 11" SEF ,
8.5 x 13" SEF , 8.5 x 14" SEF , 11 x 17" SEF ,
8.5 x 11" LEF
Use a paper type available for printing the received fax document:
plain paper, bond paper, recycled paper, side 2 paper, user-defined
custom paper.
Confirm the settings by selecting [Tools] > [Fax Service Settings] >
[Fax Control] > [Receiving Paper Size].
1. Select [Receiving Paper Size] > [Tray Mode] to add a tray to be used
for printing the received fax documents.
2. Set up paper so that the tray specified tray in [Tray Mode] can be
used for printing the received fax documents.
If the error still is not resolved, contact our Customer Support Center.
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch the machine power on again.
If the message persists, record the content displayed for [(xxx-yyy)].
Then immediately switch the main power and power off, make sure that
the touch screen is blank, and then contact our Customer Support
Center.
[Cause] An error occurred, and the operation terminated abnormally.
[Remedy] Execute the operation again.
[Cause] An auto-recoverable internal error occurred, and the machine restarted
automatically.
[Remedy] Select [Close]. to use the machine normally. If the error still is not
resolved, contact our Customer Support Center.
Cause and Remedy
5.5 x 8.5" SEF .
,
Cause and Remedy