Fuji Xerox apeosport-IV 7080 Administrator's Manual page 644

16 Appendix
Set the range from 0 to 99 mm. The default value is 0 mm. To get the active coordinates
area, subtract the area set in paper margins from the active coordinates area obtained
in the area determination mode.
Scaling Mode
Select the mode for determining the document size from the obtained active
coordinates area. Use active coordinates area to determine whether the paper
orientation will be portrait or landscape.
If it is an Active Coordinates Area
To obtain the document size, subtract the area specified in paper margins from the
active coordinates area obtained in the area determination mode.
If it is a Paper Size
Set the document size from the obtained active coordinates area and the origin point
setting. The document size can be selected from six sizes of A series paper (A0, A1,
A2, A3, A4, or A5).
How to Determine Document Size
The document size is determined by comparing with the hard clip area of each paper
size based on the active coordinates area obtained in the scaling mode, paper margin,
and area determination mode.
If the Scaling Mode is a Paper Size
1) Obtain the coordinate area to be active from the HP-GL data entered, in
2) As a margin, add the larger value of either the font size specified in the page, the
3) Subtract the value set in paper margins from the active coordinates area obtained
16
4) The minimum size that includes the active coordinates area obtained in step 3 will
If the Scaling Mode is the ACA
1) Obtain the coordinate area to be active from the HP-GL data entered, in accord
644
Paper Margins
Area obtained by area determination mode
Area remaining when paper margin subtracted
from area obtained by area determination mode
accordance with the area determination mode.
default size or one half the specified pen width, to the active coordinates area
obtained in step 1.
in step 2.
be the document size.
with the area determination mode.
Cannot plot because active
coordinates area exceeds
hard clip is exceeded