Error Code - Fuji Xerox apeosport-IV 7080 Administrator's Manual

Error Code

This section describes error codes.
An error message and error code (∗∗∗-∗∗∗) are displayed on the touch screen if printing
terminated abnormally because of an error, or a malfunction occurred in the machine.
For faxing, an error code is also displayed on an Activity Report and a Transmission
Report - Job Undelivered.
Refer to the error codes in the following table to resolve problems.
Important • If an error code is displayed, any print data remaining in the machine and information stored
If an error code is displayed that is not listed in the following table, or if you cannot
resolve an error despite following the instructions described in the table, contact our
Customer Support Center. The contact number is printed on the label or card attached
to the machine.

Error Code

003-311
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
003-318
003-319
003-320
003-321
003-322
003-323
003-324
003-325
003-326
003-327
003-328
003-329
003-330
003-331
003-332
003-333
003-334
003-335
003-336
003-337
003-338
003-339
003-340
003-341
003-342
003-343
003-344
003-345
003-346
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
in the machine's memory is not secured.
An error occurred.
and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
Cause and Remedy
Error Code
15
449