Fuji Xerox apeosport-IV 7080 Administrator's Manual page 546

15 Problem Solving
Paper Jams at the Handle [2f] and the Knob [2g]
1
Make sure that the machine is not in
operating, and open the front cover.
Important • Before pulling out the transfer module,
2
Turn the green Handle [2] at the center of
the transfer module to the right until it is in
the horizontal position and then pull the
transfer module out to the end.
3
Pull down the Handle [2f] and remove the
jammed paper.
4
Turn the Knob [2g] and remove the jammed
paper.
5
Return the Handle [2f] to the original
position.
6
Insert the transfer module completely and
turn the green Handle [2] to the left.
15
Note
7
Close the front cover.
Note
546
check the touch screen to make sure that
no paper remains in the covers of the
machine, Tray 5 (Bypass), the output tray,
HCF (A4 1 Tray) (optional), HCF (A4 2
Tray) (optional), and a finisher (optional).
Paper may be torn if paper remains in
these locations.
• If you cannot turn the handle, pull the
transfer module to the middle and insert it
again.
• If the front cover is not completely closed, a message will appear and the machine will
remain paused.