Loading Paper In Tray 8 (Inserter) (Optional) - Fuji Xerox apeosport-IV 7080 Administrator's Manual

1
Pull out the Trays 6 or 7 until it stops.
Important • While the machine is processing a job, do
• Do not add a new stack of paper on top of
2
Load and align the edge of the paper against
the right edge of the tray with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
3
Push the tray in gently until it stops.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it

Loading Paper in Tray 8 (Inserter) (Optional)

The following describes the procedure for loading paper in Tray 8 (Inserter) (optional).
Inserter allows you to set paper (blank, copied paper, etc.), which will only be used as
separators and covers, so that the machine does not output on the paper loaded in this
tray.
Note • Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
1
Hold the center of the paper guides and slide
them to the desired paper size.
2
Load the paper, neatly aligning all edges.
Important • Do not load paper above the maximum fill
not pull out the tray that the job uses.
the remaining paper in the tray to prevent
paper jams or any other troubles. First,
remove the remaining paper from the
tray, and then load the new stack of
paper.
line. It might cause paper jams or
machine malfunctions.
might cause machine malfunctions.
jams or any other troubles. First, remove the remaining paper from the tray, and then load
the new stack of paper.
line. It might cause paper jams or
machine malfunctions.
Loading Paper
2
49