Fuji Xerox apeosport-IV 7080 Administrator's Manual page 457

Error Code
016-405 [Cause]
[Remedy] Initialize the certificate.
For more information on initializing certificates, refer to "Delete All Certificates/Initialize
Settings" (P.135).
016-406
[Cause]
[Remedy] Take one of the following measures:
016-407
[Cause]
016-408
[Remedy] Modify the customized program and install it again.
016-409
016-410
016-411
016-412
016-413
[Cause]
[Remedy] Check the followings:
016-414 [Cause]
[Remedy] Check the followings:
016-417
[Cause]
[Remedy] Check the followings:
016-450 [Cause]
[Remedy] Change the host name.
Refer to "Host Name" (P.169).
016-453
[Cause]
[Remedy] Check whether the IP address of the DNS server is set correctly.
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Cause and Remedy
An error occurred in the certificate stored in the machine.
An error occurred in the SSL client certificate.
1)Store an SSL client certificate in the machine, and set it as the SSL
client certificate.
2)If the SSL client certificate cannot be set, select an authentication
method other than SSL.
After automatically obtained the IP address, the machine failed to
retrieve proxy server settings from the DHCP server.
There is a problem with the customized program registered on the
machine.
The default gateway setting
The subnet mask setting
The DNS server address settings
If the error still is not resolved after checking the above settings, there
may be a network failure or a DNS server failure. Consult your system
administrator.
A network error occurred.
The LAN cable connection
The IP address setting
The default gateway setting
The subnet mask setting
The DNS server address settings
The proxy server setting
If the error still is not resolved after checking the above settings, there
may be a network failure. Consult your system administrator.
Communications with the Xerox Communication server failed.
The IP address setting
The default gateway setting
The subnet mask setting
The DNS server address settings
The server verification feature of the destination server is disabled
If the error still is not resolved after checking the above settings, there
may be a network failure. Consult your system administrator.
The SMB host name already exists.
Updating of the IPv6 address and host name for the DNS server failed.
Error Code
15
457