Cleaning The Document Feeder Rollers - Fuji Xerox apeosport-IV 7080 Administrator's Manual

2
Hold the handle to open the chute part of the
figure on the right. Wipe the narrow glass
strip with a soft cloth moistened with water to
remove any dirt, and then wipe it with a soft
dry cloth.
Important • Do not use cleaning agents other than
Note • If dirt does not come off easily, gently
3
Push the center-left side of the document cover to close the belt area until it clicks into
place.

Cleaning the Document Feeder Rollers

If the document feeder rollers become soiled, smudges may appear on copies, faxes,
or scanned documents and paper jams may occur.
To ensure clean copies at all times, clean the document feeder roller about once a
month.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint
• Cleaning the machine with an excessive amount of water may cause the machine to
1
Lift the document feeder top cover until it is
completely open.
Note • When you fully open the cover, it enters a
2
While turning the rollers, wipe them with a
soft cloth moistened with water.
Important • Do not use cleaning agents other than
• Use a cloth firmly wrung to prevent water
Note • If dirt does not come off easily, gently
3
Close the top cover of the document feeder until it clicks into place.
4
Close the left cover of the document feeder until it clicks into place.
water or neutral detergent.
wipe it with a soft cloth moistened with a
small amount of neutral detergent.
or coating on plastic parts.
malfunction or damage documents during copying, faxing, scanning, or printing.
fixed position. Open the cover gently.
water or neutral detergent.
drops from falling into the machine. If
water gets into the machine, it may cause
the machine to malfunction.
wipe it with a soft cloth moistened with a
small amount of neutral detergent.
Cleaning the Machine
Chute
Narrow glass strip
3
75