Fuji Xerox apeosport-IV 7080 Administrator's Manual page 609

Item
Setting Item
Number
Reduce/enlarge 54
(Reduce/
enlarge mode)
17
(Variable %/
vertical
magnification)
18
(Variable %/
horizontal
magnification)
2 Up mode 21
Output 9
destination
Tray 5 67
confirmation
Grid lines 22
Sets the print magnification.
[0] (Default) : Preset %
[1] : Variable %
[2] : Fit to Cut Sheet
[Preset %] is a magnification automatically calculated based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
document to fit in the printable area of the output paper. Therefore, if the
size of the document and of the output paper are identical, the ratio will
be 100%. Also, if [2 Up] is selected, the document will be reduced to the
size at which two pages fit onto one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/
Enlarge]. A reference point for scaling (reducing/enlarging) is the upper
left corner of the printable area. This reference point applies to all text,
images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area onto the printable area
of the output paper. It is a magnification automatically calculated based
on [Original Size] and [Paper Size], and reduces/enlarges the entire
document (including the area outside of the printable area) to fit onto the
printable area of the output paper.
Sets the magnification for the vertical or horizontal direction.
[45 to 210] (Default:100): 45-210%
Note • When a continuous form paper is selected for [Original Size], print
result is identical for [Preset %] and [Fit to Cut Sheet].
Sets whether to print with the 2 Up or page by page. 2 Up is a feature
that prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the
other.
[0] (Default) : Off
[1] : Forward
[2] : Reverse
Important • When [Landscape] is selected for [Original Size], print result is
identical for [Forward] and [Reverse].
Sets the output tray for the printouts.
[0] (Default) : Right Top Tray
[80] : Finisher Tray (optional)
Prints from Tray 5, after you instruct to print and then operate the
machine to start printing.
[0] (Default) : Off
[1] : On
Sets the method for printing double-byte grid lines. The options are as
follows.
[0] (Default) : Image
[1] : Font
ESC/P-K Emulation
Value
16
609