Other Errors - Fuji Xerox ApeosPort-V 7080 Administrator's Manual

Error Code
133-710 [Cause]
[Remedy] Take one of the following measures:
Note

Other Errors

This section describes the remedies when the following messages are displayed.
Error
Message
A fault has occurred. [Cause]
Switch off the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and
(xxx-yyy)
Completed with an [Cause]
error.
[Remedy] Execute the operation again.
(xxx-yyy)
A fault has occurred. [Cause]
The machine has
rebooted. Select
[Remedy] Select [Close] to use the machine normally. If the error still is not resolved,
[Close]. If the problem
persists, call for service.
(xxx-yyy)
When printing the received fax document, the paper loaded on the bypass tray was
used for printing because the specified tray could not be used.
Load paper available for printing the received fax document.
Use a paper type available for printing the received fax document:
plain paper, bond paper, recycled paper, side 2 paper, user-defined custom paper.
Confirm the settings by selecting [Tools] > [Fax Service Settings] > [Fax Control] >
[Receiving Paper Size].
1)Select [Receiving Paper Size] > [Tray Mode] to add a tray to be used for printing the
received fax documents.
2)Set up paper so that the tray specified for [Tray Mode] can be used for printing the
received fax documents.
If the error still is not resolved, contact our Customer Support Center.
• If you cannot resolve an error despite following the instructions described in the table, contact our
Customer Support Center. The contact number is printed on the label or card attached on the
machine.
An error occurred.
then switch the machine power on again.
If the message persists, record the content displayed for [(xxx-yyy)]. Then
immediately switch the main power and power off, make sure that the touch
screen is blank, and then contact our Customer Support Center.
An error occurred, and the operation terminated abnormally.
An auto-recoverable internal error occurred, and the machine restarted
automatically.
contact our Customer Support Center.
Cause and Remedy
Cause and Remedy
Error Code
15
549