Fuji Xerox apeosport-IV 7080 Administrator's Manual page 53

5
Unscrew the screw of the front guide and
remove the guide from the tray.
6
Insert the small protrusions at the bottom of
the guide into holes corresponding to the paper size (1). Insert the screw into a hole
corresponding to the paper size on the top of the guide and tighten up the screw (2).
7
Pull the lever up of the end guide and move
it along the slot (1). Set the lever at the
position corresponding to the paper size (2)
and press the lever down (3).
Important • Adjust the end guide accordingly with the
size of paper. If the end guide is not
adjusted correctly, the machine cannot
feed the paper properly, resulting in a
paper jam.
Note • The slot on the left of 8.5" is not used.
8
Open the end guide (1) and load and align
the edge of the paper against the right edge
of the tray with the side to be copied or
printed on facing up (2).
Important • Do not load paper above the maximum fill
line. It might cause paper jams or
machine malfunctions.
9
Close the end guide tightly.
10
Push the tray in gently until it stops.
Changing the Paper Size
53
2