Fuji Xerox apeosport-IV 7080 Administrator's Manual page 452

15 Problem Solving
Error Code
012-211
012-212
012-213
012-214
012-215
012-216
012-217
012-218
012-219
012-221
012-223
012-224
012-225
012-226
012-227
012-228
012-229
012-230
012-235
012-236
012-237
012-238
012-239
012-240
012-241
012-243
012-246
012-247
012-248
012-250
012-252
012-253
012-254
15
012-255
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
452
[Cause] Finisher malfunction
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the error still is not resolved,
contact our Customer Support Center.
[Cause] The Booklet Maker is not inserted completely into the Finisher.
[Remedy] Completely insert the Booklet Maker into the Finisher, and turn the
machine off and then on.
[Cause] Finisher malfunction
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the error still is not resolved,
contact our Customer Support Center.
[Cause] The sensor was activated because the paper being output to the Finisher
was removed before the finisher tray is lowered completely into position. Or,
there is a foreign object under the finisher tray.
[Remedy] Remove any foreign object under the finisher tray. Switch off the
machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error still is not resolved, contact our
Customer Support Center.
[Cause] Finisher Tray malfunction
[Remedy] Switch off the machine power, make sure that the touch screen is blank,
and then switch on the machine power. If the error still is not resolved,
contact our Customer Support Center.
Cause and Remedy