Fuji Xerox apeosport-IV 7080 Administrator's Manual page 638

16 Appendix
Parameter
Number of
holes
180 degree
rotation
Emulation
target printer
Pen attributes
16
638
Item No.
167 Select the number of punch holes.
[0] (Default)
[1]
[2]
168 Specify the Z fold half sheet and whether to rotate landscape documents
in 180 degrees.
[0] (Default)
[1]
[2]
[3]
[4]
[5]
169 Select the machine to emulate.
[0] (Default)
[1]
800-815 (Pen Set the width (thickness of the line) of the 16 pens (No. 00 to 15). You can
width) set the width from 0.0 to 25.5 mm in 0.1 mm increments. No. 00 denotes
(No. 0-No.15) Item No. 800.
[0] - [255] (Default: 3)
Note
850-865 (Line Set the line end shape of the 16 pens (No. 00 to 15). No. 00 denotes Item
end shape) No. 850.
(No. 0-No.15) [0] (Default)
[1]
[2]
[Cut]
[Round]
[Rectangular]
Value
: 2 holes
: 3 holes
: 4 holes
: None
: Z fold half sheet (Right bind/Top bind)
: Z fold half sheet (Left bind/Bottom bind)
: None (180 degrees rotation)
: Z fold half sheet (Right bind/Top bind, 180 degrees
rotation)
: Z fold half sheet (Left bind/Bottom bind, 180 degrees
rotation))
: HP750
: FX4036
: 0 to 25.5 mm
• If the image is reduced by concern with the relationship between
[Document size] and [Paper size] settings, the pen width is reduced
accordingly to 0.1 mm at the smallest.
• The width of the line gets thick symmetrically with respect to the
center of the line.
• If the width is set to 0.0 mm, nothing is plotted.
: Cut
: Round
: Rectangular
: specified coordinate
: specified coordinate
: specified coordinate