Fuji Xerox apeosport-IV 7080 Administrator's Manual page 468

15 Problem Solving
Error Code
016-717
016-718
016-719
016-720
016-721
016-722
016-723
016-724
016-725
15
016-726
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
468
[Cause] Unable to create a Transmission Report - Job Undelivered or a
Transmission Report because the transmission result information
required for creating the report is not stored in the machine's memory.
[Remedy] Take one of the following measures:
Execute the jobs for large size Internet fax documents (about 2GB) by
splitting each document to minimize memory or HDD usage.
If many scan or Internet fax documents are being processed, wait until
the jobs are completed to execute a new job.
After completing the job that you want to confirm in a report, do not
execute 200 or more jobs before printing the report.
[Cause] Unable to process the PCL print data because of insufficient memory.
[Remedy] Reduce the resolution, or cancel 2 sided printing or N up feature, and
then print again.
[Cause] Unable to process the PCL print data because of insufficient print page
buffer.
[Remedy] Increase the size of the print page buffer.
[Cause] An invalid command is included in PCL print data.
[Remedy] Confirm the print data and try printing again.
[Cause] An error occurred during print processing. Probable causes are as
follows:
1) Printing was instructed by the Auto Paper selection when [Paper
Type Priority] is set to [Auto Paper Off] for all paper in the [Common
Service Settings].
2) ESC/P-K command error
[Remedy] For 1), when printing by the Auto Paper selection, set one of the paper
types to other than [Auto Paper Off] in [Paper Type Priority].
For 2), confirm the print data.
Refer to "Paper Type Priority" (P.131).
[Cause] The staple position specified is not supported by the machine, or the
paper size specified is not supported by the finisher.
[Remedy] Confirm the staple position and the paper size, and try printing again.
[Cause] The punch position specified is not supported by the machine, or the
paper size specified is not supported by the finisher.
[Remedy] Confirm the punch position and the paper size, and try printing again.
[Cause] The specified staple and punch position combination is unsupported.
[Remedy] Specify the staple and punch positions on the same side, and try printing
again.
[Cause] A scanned document stored in a folder was to be sent by fax using the
Job Flow feature, but the file in the folder could not be converted to fax
data.
[Remedy] Do not use the Job Flow feature. Simply scan the document from the
machine's [Fax] screen to send it by fax.
[Cause] Unable to automatically select a printer language even though the Print
mode is set to [Auto].
Probable causes are as follows:
1) PostScript data was sent with no Adobe PostScript 3 Kit (optional)
installed.
2) A PDF file was sent directly to the machine using LPR with the Adobe
PostScript 3 Kit (optional) installed but no hard disk installed.
[Remedy] For 1), the Adobe PostScript 3 Kit (optional) must be installed.
For 2), the hard disk must be installed.
Cause and Remedy