Installation When Using Ethertalk; Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox apeosport-IV 7080 Administrator's Manual

7 Printer Environment Settings

Installation When Using EtherTalk

This section describes how to install the machine using EtherTalk.
The following shows the reference section for each procedure.

Step 1 Preparations....................................................................................................................292

Step 2 Configuration on the Machine .......................................................................................292

Step 3 Configuration on the Computer .....................................................................................293
CentreWare Internet Services Setting Items .............................................................................293
Step 1 Preparations
The following items are required to set up the machine to use the EtherTalk interface.
EtherTalk network environment
The Adobe PostScript 3 Kit (optional)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use EtherTalk on the machine.
Note
7
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the [Services Home] screen.
2
Enable the EtherTalk port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [EtherTalk], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3
Select [Close] repeatedly until the [Tools] screen is displayed.
4
Select [Close].
Note
5
Print a configuration report to confirm that the EtherTalk port is enabled.
For information on how to print a configuration report, refer to "Print Reports" (P.83).
292
• EtherTalk can be configured when the Adobe PostScript 3 Kit (optional) is installed.
• You can configure the settings using CentreWare Internet Services. For the items that can
be configured using CentreWare Internet Services, refer to "CentreWare Internet Services
Setting Items" (P.293).
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.