Dtc Check; Dtc Clearance - Suzuki 2006 SX4 Service Manual

10C-6 Immobilizer Control System:

DTC Check

NOTE
To know how to use SUZUKI scan tool in
detail, refer to its operator's manual.
1) Turn the ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located under instrument panel at driver's
seat side.
Special tool
(A): SUZUKI scan tool (SUZUKI-SDT)
1
(A)
3) Turn the ignition switch to ON position.
4) Read DTC according to instructions displayed on
SUZUKI scan tool and print them or write them
down. Refer to scan tool operator's manual for
details.
If communication between scan tool and ECM is not
possible, go to "Troubleshooting for Communication
Error with Scan Tool Using CAN in Section 1A".
5) After completing the check, turn ignition switch to
OFF position, and then disconnect SUZUKI scan
tool from DLC.

DTC Clearance

S6RW0DA304002
NOTE
To know how to use SUZUKI scan tool in
detail, refer to its operator's manual.
1) Turn the ignition switch to OFF position,
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located under instrument panel at driver's
seat side.
Special tool
(A): SUZUKI scan tool (SUZUKI-SDT)
I5RW0CA30002-01
3) Turn the ignition switch to ON position.
4) Clear DTC(s) according to the instructions displayed
on SUZUKI scan tool.
5) After completing the clearance, turn the ignition
switch to OFF position, and then disconnect SUZUKI
scan tool from DLC.
1
(A)
S6RW0DA304003
I5RW0CA30002-01