Setting Leaf Media - MIMAKI TX500-1800DS Operation Manual

Setting leaf media

Unlike roll media, leaf media does not need to be retained with the roll holders.
1
Open the front cover.
2
Raise the clamp lever.
3
Insert the leaf media between the platen and the
pinch rollers.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• Set the media so that the media end does not reach the slot
of the post-heater.
4
Hold the media with the fabric retainer gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the fabric retainer from
the media before printing.
5
Push down the clamp lever.
• Set the media straight.
6
Close the front cover.
2-24
• If the media gets near to the right side too much,
the warning on the right is displayed after media
detection. Set the media again.
Clamp lever
Front cover
Pinch roller
Fabric retainer
ERROR 5 1 6
MED I A SE T POS I T I ON R