Set the media feeding
Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor
printing.
• When you have changed the media type, check the pattern and perform adjustment depending on the
status.
• When you have changed the temperature of the heaters, make sure that the [CONSTANT] lamp lights
up and that the preset temperature is reached, and then start the correction.
• When printing with a take-up device, set the media first and then perform media correction.
Flow of media feeding correction
Perform media feeding correction as below:
1
Press the
check that the feed correction
setting value is "0".
2
Make the torque of the brake roller
and tension roller biggest.
3
Print the correction pattern.
4
Check the pattern and adjust the
counter weight of take-up/ feeding
tension bar.
5
If correction by counter weight
adjustment is not enough, adjust
the torque.
6
If correction by counter weight/ torque
adjustment is not enough, input the
correction value in the feed correction
2-34
key, and
Referring to "Setting Feed Correction"
(
Referring to "Setting the torque limiter"
(
Referring to "Setting Feed Correction"
(
Referring to "Installing the counter weight for
adjusting the take-up/ feeding tension-bar
weight" (
Referring to "Setting the torque limiter"
(
Referring to "Setting Feed Correction"
(
P.2-3).
P.2-5).
P.2-28).
P.2-22).
P.2-30).
P.2-31).