Setting The Amount Of Blank Space Between Printed Lines - MIMAKI TX500-1800DS Operation Manual

Setting the amount of blank space between printed lines

Sets the amount of blank space between printed lines.
1
Press the
2
Press
3
Press the
4
Press
5
Press the
6
Press
• Set value : OFF / 10 to 500mm
7
Press the
8
Press the
Back-feed operation is performed when printing ends if the amount of blank space is set in the
decreasing direction.
Be careful of the following in such cases.
• If media is set in the roll holder without using the feeding device on the back of the printer, the media
tension of the next printing will change due to back-feed, possibly causing the feed rate of the media
of only the leading edge of the printed image to change. In such cases, manually rewind the media.
• This function is disabled if back-feed after drying feed is set to OFF in the machine settings "DRYING
FEED" (
• If the printed data already has a blank space, using this function will result in "Blank space of the data
+ Amount of blank space set by using this function" being output as a blank space.
3-26
key in LOCAL.
to select [MACHINE SETUP].
key.
to select [SPACE BTWN PP.].
key.
to set the amount of blank space.
key.
key several times to end the setting.
P.3-25).
F UNC T I ON
S E TUP < EN T >
F UNC T I ON
MACH I NE SE T UP [ EN T ]
MACH I NE SE T UP
AU TO P o w e r - o f f [ EN T ]
MACH I NE SE T UP
S P ACE B TWN PP . [ EN T ]
S P ACE B TWN PP .
= OF F
S P ACE B TWN PP .
= 1 0 0 mm
MACH I NE SE T UP
S P ACE B TWN PP . [ EN T ]