5
Using the switch of the feeding device, feed out the
fabric around 3m.
(1) Set the switches to the feeding direction of the media.
(2) Turn to "MANUAL" and feed out the fabric around 3m.
• With the lapse of 3 seconds, the rotation will automatically be turned off.
• If you wish to stop the rotation prior to the lapse of 3 seconds, turn the switch to "AUTO".
• In case where the tension bar of the feeder unit is not locked, the rotation does not stop
automatically even with the lapse of 3 seconds. If you desire to stop the rotation, turn over the
switch to "AUTO".
• When the rotation stops automatically, and you wish to feed out the media further, turn the
switch from AUTO to MANUAL.
6
Pass the fabric through into the rear side of the turning
bar 1.
7
From outside of the feeding tension bar, pass the fabric
through onto the turning bar 2.
8
Pass the fabric through under the turning bar 3, and
cover the brake roller with the fabric.
9
Insert the top edge of the fabric between the grit roller
and the pinch roller, and feed the media to the front of
the machine.
• At this time, remove waviness on the surface of the fabric
etc.
Setting a Media
Turning bar 1
Turning bar 2
Feeding tension bar
Brake roller
Turning bar 3
2-15
1
2
4
5
6