Table of Contents
Advertisement
6
Set the syringe with pressure damper to the ink
port valve.
• Insert the syringe with pressure damper into the ink port
valve and suck out ink of 5cc (at a speed of 3 sec. per cc)
slowly.
• Do not push the valve part of the syringe with
• When discarding ink in the syringe, remove the
7
Discharge ink or purge air.
• The discharged ink or air is pooled in the bottle of the air purge jig.
• Discharge mixed ink or air completely. When it is discharged completely, clear ink (not mixed) is
discharged.
8
Perform the procedures from 5 to 7 on all ports which have to be purged the air.
9
Press
completed.
10
Terminate air purge by pressing the
• Close the port.
• When some port is skipped the air-purge, press
the step 4.
11
Press
• Cleaning is performed.
12
Press
• Be aware that if you leave the device for a long time during the air purge, ink may leak from the cap
section.
If the air purge continues for 20 minutes or longer, this device forcibly shuts down the air purge in
order to prevent ink leaks.
5-8
pressure damper. Otherwise, ink absorption
cannot be performed.
syringe part from the tube and then discard it. If
you remove the syringe part, ink in the tube
may run down. Before performing the work, it is
recommended to cover around it with a waste
close etc. to prevent it from stained.
key after all procedures are
.
the key several times to end the setting.
Tube
A I R PG
COMP L E T ED
key.
A I R PG
END <
to return to
* * C L EAN I NG * *
P L E A SE WA I T
Syringe
Valve part
[ EN T ]
> RE TRY
Advertisement
Table of Contents
