Table of Contents
Advertisement
Message
E R ROR 3 0 5
U S B T I ME OU T
E R ROR 4 0 1
MO T OR X
E R ROR 4 0 2
MO T OR Y
E R ROR 4 0 3
X C U R R E N T
E R ROR 4 0 4
Y C U R R E N T
E R ROR 4 2 3
T A K E - U P T E N S I ON B A R
E R ROR 4 2 4
F E E D I NG T E N S I ON B A R
E R ROR 4 2 5
T a k e - U P WRONG
E R ROR 4 2 6
F e e d i n g WRONG
E R ROR 4 2 7
T a k e - U P C o v e r O P E N
E R ROR 4 2 8
F e e d i n g C o v e r O P E N
E R ROR 4 2 9
T a k e - U P L i m i t D E T E C T
E R ROR 4 2 a
F e e d i n g L i m i t D E T E C T
E R ROR 4 4 d
S T A T I ON P O S E R ROR
Cause
Occurrence of a time out error on a
USB device.
An excessive load was applied to the
X motor.
An excessive load was applied to the
Y motor.
An error due to an excessive current
of the X motor was detected.
An error due to an excessive current
of the Y motor was detected.
An error was detected in the take-up
tension bar at media set check when
starting printing.
An error was detected in the feeding
tension bar at media set check when
starting printing.
An error occurred in the take-up sta-
tus of the take-up unit.
An error occurred in the feeding sta-
tus of the feeding unit.
The take-up cover opened during
printing.
The feeding cover opened during
printing.
The take-up limit sensor was detected
during printing.
The feeding limit sensor was detected
during printing.
An error occurred in the station posi-
tion.
Warning / Error Messages
Solution
• Turn off the main power to the machine and
turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Check the media set status, and solve the
problem.
• Check the media set status, and solve the
problem.
• Check that the media can be taken up to
the take-up unit.
• Check that the paper core taking up the
media does not run idle.
• Check that the media can be taken up to
the feeding unit.
• Check that the media does not run idle.
• Close the take-up cover.
• Close the feeding cover.
• Lower the tension bar or move it to the wait-
ing position.
• Lower the tension bar or move it to the wait-
ing position.
Turn off the main power to the machine and
turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
1
1
1
1
5
5-19
Advertisement
Table of Contents
