Checking Spacer - MIMAKI TX500-1800DS Operation Manual

Checking spacer

Depending on the media you use and the printing method, set the spacer type (attached three types).
About each spacer
This machine provides three spacers below:
Ink receiving spacer
 When printing on the fabric (when over print is not performed)
Use ink receiving spacer. (
 When printing on the fabric (when over print is performed)
Use the ink receiving spacer and the fabric edge spacer. (
 When you perform Drop Position correct
Use the adjusting spacer.(
Fabric edge spacer
P.2-8 )
P.2-8 )
Adjusting spacer
P.2-8 )
Setting a Media
2-7
1
2
4
5
6