Table of Contents
Advertisement
Setting Feed Correction
A pattern for media correction is printed and a media-feeding rate is corrected.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is obtained in the boundary between the two bands.
1
Set a media. (
2
Press the
3
Press the
• If you input the correction value only, first press the
and then press the
screen is displayed. Operate the procedures in the Step 5, input
the correction value.
4
Press the
5
Check the correction pattern and enter a correction
value.
Enter a correction value in "+": The boundary between the two bands is widened.
Enter a correction value in "-": The boundary between the two bands is narrowed.
2-36
First band
P.2-5)
key in LOCAL.
key.
key. The correction value input
key to print a correction pattern.
• When you change the correction value by "20", the band moves about 0.01mm. By
referring to this correction amount, determine the correction value.
Second band
key,
Media advance direction
F E ED COMP .
[ EN T ]
F E ED COMP .
PR I N T
[ EN T ]
* * PR I N T I NG * *
P L E A SE WA I T
F E ED COMP .
=
0
Advertisement
Table of Contents
