Setting Margins - MIMAKI TX500-1800DS Operation Manual

Setting Margins

Set a non-printing area along the right and left edges of the media.
The offset value against the standard margin 15mm is set hereupon.
• When you give priority to the setting at the RIP software side, make the setting value "Host".
• You cannot specify the margins at the attached RIP software (RasterLink). When you use the
RasterLink, if you set this machine to "Host", printing will be performed in "Margins for right and left off
set value= 0 mm" status.
• Available printing area of this machine is automatically detected depending on the set position of
fabric retainer at the right and left of the media. When you change margins, printing area is changed
as below:
(1) When you set the margin to "0", detected printing area will be the printing area directly.
(2) When you set the margin to "- (minus)", the printing area will be wider than detected printing
area by the set value.
(3) When you set the margin to "+ (plus)", the printing area will be narrower than detected
printing area by the set value.
When you set it to "-
(minus)", the printing
area will widen.
1
Press the
2
Press the
3
Press
4
Press the
5
Press
• This was set to "HOST" (RIP software side setting has priority)
before shipping. Change this when you want to set the left margin
of media to the setting value of this machine.
Set Value : HOST or -10 to 85mm (in 1mm increment)
3-6
When you set it to "+
(plus)", the printing
area will narrow.
key in LOCAL.
key.
to select [MARGIN].
key.
to set the left margins.
Printing area when
margin is "0"
F UNC T I ON
S E TUP
S E TUP
F E ED COMP .
S E TUP
MARG I N
L E F T
=
L E F T
=
[ EN T ]
[ EN T ]
[ EN T ]
0 mm
HOS T