Table of Contents
Advertisement
If nozzle missing due to color mixture of ink or aeration
If nozzle missing occurs due to color mixture of ink in the head or aeration, push ink or air in the head out from
the port.
• While performing the work below, ink may leak from the cap part.
Using a waste cloth etc., prevent ink stain on the valve part.
1
Select [AIR PG] of the maintenance menu.
(1) Press the
(2) Press
(3) Press
2
Press the
3
Remove the right front cover and the right
maintenance cover, and then remove head cover.
4
Press the
5
Discharge the ink from the valve of the Y-port.
• Insert the syringe into the valve of Y-port and then slowly
withdraw about 10cc of the ink.
• Be careful not to spatter the ink around during
the work.
• Mask the around valves properly with the waste
cloth or adequate materials in order to protect
the circuit board that is closely placed.
key in LOCAL.
to select [MAINTENANCE] and press the
to select [AIR PG].
key.
key.
Troubleshooting
key.
PREP ARE A I R PG
COMP L E T ED
Right front cover
Right maintenance cover
A I R PG
S T AR T
1
[ EN T ]
1
1
[ EN T ]
1
5
5-7
Advertisement
Table of Contents
