Connecting Cables; Connecting Usb2.0 Interface Cable - MIMAKI TX500-1800DS Operation Manual

Connecting Cables

Connecting USB2.0 Interface Cable

Connect the PC and this machine with the USB2.0
interface cable.
• Your RIP must be compatible with USB
2.0.
• Contact a RIP maker near your location or
our office when the USB2.0 interface is not
attached to the PC.
Notes on USB 2.0 Interface
• Your RIP must be compatible with USB 2.0.
 When two or more Tx500 machines are connected to one personal computer
When two or more Tx500 machines are connected to one personal computer, the personal computer may not
recognize all the Tx500 machines normally.
Reconnect the unrecognized Tx500 machine to another USB port, if available, and check to see if it is
recognized.If the Tx500 machine is not recognized by the newly connected USB port, use USB 2.0 repeater
cables available on the market.
 Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is connected to
the same personal computer that a Tx500 machine is connected to, the USB device may not be recognized.
When Tx500 is connected to the personal computer to which an external HDD is connected via USB, the speed
of data output to Tx500 may drop.That can cause the head unit to stop temporarily at the right or left end during
printing.
1-10
USB cable
USB 2.0 repeater cable