Changing The Printing Origin - MIMAKI TX500-1800DS Operation Manual

How to check the value of the head gap
When you check the head gap value currently set, perform the following procedures:
Press the key in Local.
Setting the head gap without
You can set the head gap by using the
Press the
key in Local.

Changing the printing origin

The position of the printing origin can be changed.
1
In Local, Press
• It enters into the origin setting mode.
2
Press
• Select the carriage and media, moving the point with
3
After determining the origin, press the
• The printing origin is changed.
When Changing the Origin
When the media is automatically detected, the starting
point for printing (the origin) is set at the point shown in the
diagram in the right.
You may change the Origin according to the printing status.
Press the
• The head gap value currently set is displayed.
key in the Local without pressing the
Press to select
[SETUP], and press the
key.
.
to set the origin to a desired position.
.
key several times to display [HEAD GAP].
key
Press to select [HEAD GAP], and
press the key.
• The screen in the Step 2 is displayed.
Perform the procedures from the Step 3.
Origin
(Length)
key.
Origin
Setting a Media
key.
OR I G I N SE T UP
0 . 0 - - - -
OR I G I N SE T UP
0 . 0 0 . 0
Origin
(Width)
OR I G I N SE T UP
* * OR I G I N * *
Fabric
retainer
10 ㎜
2-27
1
2
4
5
6