Table of Contents
Advertisement
10
Pull down the clamp lever of the rear side of the
equipment.
• The fabric is maintained.
11
Go to the front of the machine, raise the clamp lever
while holding the top edge of the fabric with your
hand, and pull out the fabric.
12
Pass the fabric through onto the turning bar 4/ 5 from
the front side of the take-up tension bar.
13
Pull out the fabric until the top edge of the fabric
nearly touch the floor and remove the wrinkles, etc.
• Make both of the front surface and the rear surface of the
machine without waviness etc.
14
By operating the switch of the feeding device at the
rear surface of the machine, take up the top edge of
the fabric at the take-up side to the position where it
can be pasted on the set paper core.
(1) Set the switch to the reverse direction of the media
feeding.
(3) Turn to "MANUAL" and take up the fabric.
15
Push down the clamp lever.
• The fabric is retained.
2-16
Clamp lever
Turning bar 4/5
Take-up tension bar
Advertisement
Table of Contents
