Table of Contents
Advertisement
6
Press the
• Multiple test patterns are printed. (The printed patterns are called
Pattern 1, Pattern 2, Pattern 3... in the order of printing.)
7
Press
1~.
• Corrected feeding rate: -40.0 to 40.0
• Check the test patterns. The position where an outward feeding
line and a return feeding line become one straight line is the
correction value.
• When the correction value in not between -40.0 and 40.0, adjust
the head gap and then perform the operations in Step 2 and later.
8
By pressing the
• The screen to correct the next pattern is displayed. Repeat the
procedures from the Step 5 to correct all patterns.
• After correcting all patterns, perform the procedures in the Step 7.
9
Press the
Performing to correct the dot position without
You can select "DROP.POScorrect" by using the
key.
Press the
key in Local.
Correct the ink drop position for bidirectional printing
key to start pattern printing.
to correct the dot position of Pattern
key, register the correction value.
key several times to end the setting.
Press
to
select [SETUP], and
press the
key.
P A T T ERN 1
=
P A T T ERN 2
=
key in the Local without pressing the
Press
to select [DROP.POScorrect],
and press the
key twice.
• The screen in the Step 3 is displayed. Perform
the procedures from the Step 4.
* * PR I N T I NG * *
P L E A SE WA I T
0 . 0
0 . 0
key
2-39
1
2
4
5
6
Advertisement
Table of Contents
