Table of Contents
Advertisement
Attaching/removing ink receiving spacer and fabric edge spacer
When printing, to prevent media from staining due to ink mist, be sure to set the ink receiving spacer.
1
Move the fabric retainer to the left and the
right.
2
Attach the ink receiving spacer and the
fabric edge spacer.
• The size of the ink receiving spacer is W: 250 mm
x D: 177 mm.
Depending on the width of the image to be printed,
adjust the number of ink receiving spacers to
attach.
Reference for attaching ink receiving spacer / fabric edge spacer
• Make the total width of the ink receiving spacer and the fabric edge spacer not be narrower than the
width of the image to be printed.
• Adjust the number of spacers so that they are apart from right and left edges of the image by 10mm
and more.
• Move the edge of fabric edge spacer closer to the edge of media as
much as possible.
Make the amount of over
print be 20mm and less.
10mm or more
2-8
Media
Printing width
Gap between ink receiving spacers depending on the
media width to adjust the gap so that it may be even.
Ink receiving
Fabric edge spacer
Make the amount of over
Ink receiving spacer
print be 20mm and less.
10mm or more
Fabric edge
spacer
Fabric
edge
spacer
Advertisement
Table of Contents
