Cautions And Notes - MIMAKI TX500-1800DS Operation Manual

CAUTIONS and NOTES

Handling of ink bottles
• Use the Tx500 genuine ink. Remember that the user shall
be filled for a repair to correct any damage resulting from
the use of ink other than the exclusive type.
• The machine does not operate with any ink other than the
Tx500 genuine ink.
• Do not use the Tx500 genuine ink with other printers, as
doing so may cause damage to such machines.
• If the ink bottle is moved from a cold place to a warm
place, leave it in the room temperature for three hours or
more before using it.
• Open the ink bottle just before installing it in the machine.
If it is opened and left for an extended period of time,
normal printing performance of the machine may not be
ensured.
• Make sure to store ink bottles in a cool and dark place.
• Store ink bottles and waste ink tank in a place that is out
of the reach of children.
• Be sure to thoroughly consume the ink in the ink bottle,
once it is opened, within three months. If an extended
period of time has passed away after opening the ink
bottle, printing quality would be poor.
• Neither pound the ink bottle nor shake it violently, as
doing so can cause leakage of ink.
• Do not touch or stain the contacts of the IC chip, as doing
so may cause damage to the print circuit board.
• Waste ink is equivalent to waste oil of industrial waste.
Request an industrial waste disposal company for
disposal of waste ink.
Notes on maintenance
• It is strongly recommended to use the machine in a room that is not dusty.
• Keep the front cover closed even when the machine is not printing. If not, dust can accumulate on the nozzles in the
heads.
• Dust in the heads can also cause drops of ink to fall suddenly down on the media during printing. In such a case, be
sure to clean up the heads. (P.4-18 "Cleaning the Head and the Area around It")
• When cleaning the ink-station or the heads, make sure to wear the attached gloves.
• Perform wiping (removal of dust and paper powder) of the capping station and wiper frequently.
Periodic replacement parts
• Some parts of this machine must be replaced with a new one periodically by service personnel. Be sure to make a
contract with your distributor or dealer for After sale service to ensure a long life of your machine.
Disposition of this machine
• When discarding this machine, request the treatment of it for an industrial waste disposal contractor.
• Treat it properly in compliance with regulation in the local area.
ix
Warning
Front cover and lever
• Never open the front cover or raise the lever during
printing. Opening the cover or raising the lever will abort
printing.
Handling of media
• Use media recommended by MIMAKI to ensure reliable,
high-quality printing.
• Set the heater temperature to meet the characteristics of
the media. Automatic temperature setting can be made on
the operation panel by setting the profile on the dedicated
RIP. For setting on the RIP, refer to the instruction manual
for your RIP.
• When using a fabric with curling, be sure to remove the
curling before using. Strong curling may effect on the
quality of printing or may hit the head nozzle surface and
may cause discharging defect.
• Do not leave pre-treated fabric media set. Medicant of
pre-treatment agent may promote rust of the grit roller.
• Do not leave the media with the heater ON for a long time.
Protection of media from dust
• Store media in a bag. Wiping off dust accumulated on
media will adversely affect the media due to static
electricity.
• When leaving the workshop after the working hours, do
not leave any media on the roll hanger. If any media is left
on the roll hanger, it can get dusty.
Warning