Table of Contents
Advertisement
Clutch Replacement
Special Tools Required
• Clutch alignment shaft 07LAF-PT00110
• Clutch alignment disc 07JAF-PM7011A
• Remover handle 07936-3710100
• Ring gear holder 07LAB-PV00100 or
07924-PD20003
Pressure Plate and Clutch Disc Removal
1. Assemble the special tools as shown. Assemble the
Clutch A l i g n m e n t Disc w i t h side marked "A"
facing
the diaphragm spring.
2. Check the diaphragm spring fingers for height
using the special tools and a feeler gauge (A). If the
height is more than the service limit, replace the
pressure plate.
S t a n d a r d (New):
0.6 m m (0.02 in.) max.
Service Limit:
0.8 m m (0.03 in.)
0 7 9 3 6 - 3 7 1 0 1 0 0
< 3 ®
3. Install the special tools.
A
B
0 7 L A F - P T 0 0 1 1 0
0 7 9 2 4 - P D 2 0 0 0 3
4. To prevent w a r p i n g , unscrew the pressure plate
mounting bolts (A) in a crisscross pattern in several
steps, then remove the pressure plate (B).
5. Inspect the pressure plate (A) surface for wear,
cracks, and burning.
B
A
6. Inspect the fingers of the diaphragm spring (B) for
wear at the release bearing contact area.
(cont'd)
12-7
Advertisement
Table of Contents
Troubleshooting
