Table of Contents
Advertisement
Manual Transmission
Transmission Reassembly (cont'd)
8 . Remove the dirt and oil from the transmission
housing sealing surface. Apply liquid gasket (P/N
08718-0001) to the sealing surface. Be sure to seal
the entire circumference of the bolt holes to
prevent oil leakage.
NOTE: If 20 minutes have passed after applying
liquid gasket, reapply it and assemble the housings.
Allow it to cure at least 20 minutes after assembly
before filling the transmission with oil.
9. Install the 14x20 mm dowel pins.
10. Set the tapered cone ring (A) as shown. Place the
transmission housing over the clutch housing,
being careful to line up the shafts.
11. Lower the transmission housing the rest of the way
as you expand the snap ring (A). Release the snap
ring so it seats in the groove of the countershaft
bearing.
12. Check that the snap ring (A) is securely seated in
the groove of the countershaft bearing.
Dimension ® as installed: 3 . 6 - 6 . 3 mm
(0.14-0.25 in.)
B
3 2
m m
13. Apply liquid gasket (P/N 08718-0001) to the threads
of the 32 mm sealing bolt (B), and install it on the
transmission housing.
13-50
Advertisement
Table of Contents
Troubleshooting
