Clutch Master Cylinder Replacement - Honda 2002 Accord Manual

Clutch Master Cylinder Replacement
NOTE: Do not spill brake fluid on the vehicle; it may
damage the paint; if brake fluid does contact the paint,
w a s h it off i m m e d i a t e l y w i t h water.
1. Remove the brake fluid from the clutch master
cylinder reservoir (A) w i t h a syringe.
A
2. Disconnect the reservoir hose (B) f r o m the clutch
master cylinder reservoir. Plug the end of the
reservoir hose w i t h a shop towel to prevent brake
fluid f r o m c o m i n g o u t
3. Remove the clutch master cylinder reservoir.
4. Remove the p o w e r relay (C).
5. Pry out the lock pin (A), and pull the pedal pin (B)
out of the yoke. Remove the nuts (C).
C
Remove the retaining clip (A). Disconnect the clutch
line (B), and remove the O-ring (C). Plug the end of
the clutch line w i t h a shop towel to prevent brake
fluid f r o m c o m i n g out.
7. Remove the clutch master cylinder (D), then
remove the reservoir hose (E) f r o m the clutch
master cylinder (D).
8 . Install the clutch master cylinder in the reverse
order of removal. Install the new O-ring. Tighten
the master cylinder mounting nuts to 13 N - m (1.3
kgf-m, 9.4 Ibf-ft).
9. Bleed the clutch hydraulic system (see step 5 on
page 12-6).
12-5