Table of Contents
Advertisement
17. Remove the cotter pins (A), and loosen the castle
nuts (B), then separate the ball joints and lower
arms (C) on both sides (see step 3 on page 18-17).
18. Remove the both damper forks (D).
19. Pull the driveshafts out of the intermediate shaft
and differential (see page 16-3). Coat all the
precision finished surfaces w i t h clean engine oil
grease. Tie bags over the driveshaft ends.
20. Remove the intermediate shaft. Coat all the
precision finished surfaces w i t h clean engine oil
grease. Tie bags over the shaft end.
2 1 . Remove the engine stiffener.
(cont'd)
13-7
Advertisement
Table of Contents
Troubleshooting
