Disassembly And Assembly; Selector Mechanism - Audi TT 2007 Repair Manual

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
5

Disassembly and Assembly

⇒ "5.1 Selector Mechanism", page 128
⇒ "5.2 Transmission without Circlip A for Cap/Input Shaft",
page 131
⇒ "5.3 Transmission with Circlip A for the Cap/Input Shaft", page
142
⇒ "5.4 Shift Forks", page 152
⇒ "5.5 Transmission Housing", page 152
⇒ "5.6 Clutch Housing, Servicing", page 158
5.1

Selector Mechanism

Special tools and workshop equipment required
♦ Thrust Block -T10083-
Disassembling
– Remove the shift mechanism. Refer to
⇒ "4.2 Selector Mechanism", page 91
– Bend open the tabs -arrows- of the base plate with a screw‐
driver and remove the base plate.
– Remove seal from shift housing.
– Remove shift cable and selector cable from selector housing.
Refer to
⇒ "2.4 Shift Lever and Shift Housing for Vehicles from VIN
8J-7-013001 Assembly Overview", page 59
– Raise upper side of spring -A- over selector bracket tab.
– Using a screwdriver, press the bearing shell catches
-arrows- in the direction of the shift lever guide bearing; break
off the catches if necessary.
– Pry out bearing shell -A- with shift lever guide and shift lever
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
-B- from selector housing.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Then press bearing shell off shift lever guide bearing and re‐
move.
Note
Observe guides -A- in subsequent steps.
♦
They must not break off.
♦
128
Rep. Gr.34 - Controls, Housing
.
.