Audi TT 2007 Repair Manual page 9

ties", page 9 , Specification, refer to the electronic parts
catalog ETKA.
Shaft Seals, Sealing Rings, O-rings, Seals
♦ Always replace shaft sealing rings, O-rings, and seals.
♦ After removing gaskets and seals, always inspect the contact
surfaces at housing or shaft for burrs resulting from removal,
or for other signs of damage.
♦ Before installing the shaft seals, lightly oil the outer circumfer‐
ence and fill the space between the sealing lips -arrow- half‐
way with sealing grease -G 052 128 A1- .
♦ The open side of the shaft seals point toward the fluid to be
sealed in.
♦ When pressing in new shaft seal, make sure the sealing lip
does not run on the same point as the sealing lip of the old
seal (use insertion depth tolerances).
♦ To prevent crushing when installing, lightly lubricate O-rings
before inserting.
♦ After replacement of seals, O-rings, and shaft sealing rings,
check the oil level in the manual transmission. Refer to
⇒ "1.1 Manual Transmission, Checking Gear Oil Level", page
47 or in the bevel box
⇒ "1.2 Gear Oil in Bevel Box, Checking", page 48
Sealant
♦ Thoroughly clean housing joint surfaces before applying seal‐
ing compounds.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
♦ Apply the sealing compound -AMV 188 200 03- evenly and not
with respect to the correctness of information in this document. Copyright by AUDI AG.
too thick.
♦ Do not allow sealing compound to enter ventilation openings.
Fasteners
♦ Do not stretch the circlips.
♦ Replace damaged or stretched circlips.
♦ Circlips must locate properly in the groove.
♦ Replace spring pins. Installed position: the slit -A- should be
in line with the line of force -arrow-.
Bolts and Nuts
Manual Transmission - Edition 10.2009
.
Audi TT 2007 ➤
1. General Information
3