Audi TT 2007 Repair Manual page 229

❑ 40 Nm
12 - Bolt
❑ Screw together with threaded piece -19-
❑ Tightening specification -13-
13 - Right Drive Flange
❑ Removing and installing, refer to
14 - Bevel Box
❑ Removing and installing with transmission installed, refer to
❑ Removing and installing with transmission removed, refer to
⇒ "5.2 Transmission without Circlip A for Cap/Input Shaft", page 131
15 - Large Differential Bevel Gear
❑ Installing ⇒ page 240
16 - Differential Taper Axle
❑ Removing ⇒ page 240
❑ Installing ⇒ page 240
17 - Spring Pin
❑ For securing the axle for the differential bevel gear
❑ Removing ⇒ page 240
❑ Drive new roll pin in flush
18 - Small Differential Bevel Gear
❑ Removing and installing
19 -
Threaded Piece
❑ Installing ⇒ page 240
20 - Thrust Washer Union
❑ Install coated with gear oil
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
21 - Securing Ring
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Holds tapered ring, thrust washer and compression spring in position with flanged shaft removed
22 - Tapered Ring
❑ With grooves to engage thrust washer
❑ Installed position: ball toward the differential housing
23 - Thrust Washer
❑ Installed position: collar towards spring, tab toward tapered ring
24 - Left Flange Shaft Spring
❑ installed behind left flange shaft
25 - Flange Shaft, Left
❑ Removing and installing, refer to
26 - Shaft Seal
❑ For left flange shaft
❑ Replace with transmission installed, refer to
⇒ page 223
⇒ page 220
⇒ "3.4 Right Flange Shaft", page 230
⇒ page 241
⇒ page 240
⇒ "3.1 Left Flange Shaft", page 228
⇒ "3.2 Left Flange Shaft Seal", page 228
Manual Transmission - Edition 10.2009
⇒ "4.11 Bevel Box, Removing", page 118
1. Description and Operation
Audi TT 2007 ➤
223