Audi TT 2007 Repair Manual page 90

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
10 - Oil Deflector Ring
❑ Installed position: shoulder at hole points toward output shaft
11 - Taper Roller Bearing Outer Race
❑ For output shaft for 1st to 4th gear
❑ Removing and installing, refer to
❑ In the event of replacement: adjust the output shaft for 1st to 4th gear, refer to
⇒ "2.3 Output Shaft, 1st to 4th Gears, Adjusting", page 183
12 - Taper Roller Bearing Outer Race
❑ For output shaft 5th/6th gear/reverse gear
❑ Removing and installing, refer to
❑ In the event of replacement: adjust the output shaft for 5th/6th gear and reverse gear, refer to
⇒ "2.5 Output Shaft for 5th/6th Gear and Reverse Gear, Adjusting", page 188
13 - Adjustment Shim
❑ For output shaft for 5th/6th and reverse gear
❑ 0.65 mm thick
14 - Roller Bearing
❑ For input shaft
❑ Removing and installing, refer to
15 - Magnet
❑ Held in place by housing joint surface
16 - Cap
❑ Installed only on clutch housing for 4-cylinder engine
Axle for Reverse Gear Shift Fork to Transmission Build Date
5/24/09
– Mount reverse gear shift fork -1- on axle -2- behind 5th/6th
gear selector rod -3-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
84
Rep. Gr.34 - Controls, Housing
⇒ "3.2 Output Shaft, 1st to 4th Gears", page 194
⇒ "3.3 Output Shaft for 5th/6th Gear and Reverse Gear", page 202
⇒ "3.1 Input Shaft", page 192