Audi TT 2007 Repair Manual page 135

– Swivel lower spring leg -arrow 1- onto the selector bracket
shoulder.
Caution
Lower spring leg -arrow 1- can spring down uncontrolled from
the selector bracket shoulder during subsequent handling.
– Now raise the shift lever guide up as far as the stop and re‐
move the ball stud from the selector bracket -arrow 2-.
– Carefully press the spring -arrow 1- off of the selector bracket
shoulder.
The spring legs are then tensioned diagonally.
– Then turn the shift lever in direction of -arrow 1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
• The pins -arrow 2- must be in the shift housing opening.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Then tip the shift lever guide with the shift lever out in the di‐
rection of -arrow 3-.
Assemble Shift Mechanism
– Release the tension on legs -A- and -B-.
• Sides -A- and -B- must face in the opposite direction. (Shown
here with the shift lever guide inserted.)
– Insert the shift lever guide with shift lever in the shift housing.
• The pins -arrow 1- are still located in the shift housing opening.
– Turn the shift lever guide in direction of -arrow 2- until the ball
head pin -A- is above the shift housing opening.
Manual Transmission - Edition 10.2009
5. Disassembly and Assembly
Audi TT 2007 ➤
129