Audi TT 2007 Repair Manual page 111

Metal selector relay lever -1-:
– Remove lock washer -arrow- and remove selector relay lever
-1-.
Plastic selector relay lever -1-
– Remove the selector relay lever with catch
– Remove the selector relay lever with catch
All Vehicles
– Remove engine/transmission connecting bolt -arrow- (engine
side).
– Remove engine/transmission connecting bolt -arrow- near
bevel box -C-.
Make sure securing clip -A- for bolt -arrow- in engine oil pan -B-
is installed.
Transmission support -3282- is equipped with -3282/33- to re‐
move transmission "02Q".
– Place -3282- in -V.A.G 1383 A- .
– Align arms of transmission support according to holes in ad‐
justment plate .
– Install support elements -A- onto adjustment plate as shown.
– Install -3282/29- in place of attachment -C-
– Place -V.A.G 1383 A- under the vehicle with the arrow symbol
-B- on the adjustment plate pointing in the direction of travel.
– Align adjustment plate and transmission parallel to one an‐
other.
– Screw -3282/29- into hole for mounting bolt of pendulum sup‐
port on transmission.
⇒ page 68
⇒ page 69
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
4. Removal and Installation
Audi TT 2007 ➤
105