Audi TT 2007 Repair Manual page 79

Caution
♦ In the case of 02Q man‐
ual transmissions, threa‐
ded inserts (HeliCoil) can
be installed in the threads
of the pendulum support
threaded connection.
These threaded inserts
are standard as of trans‐
mission build date
5/28/07.
♦ Difference ⇒ page 74
♦ Bolts with strength cate‐
gory 10.9 must be used
for all transmissions with
threaded inserts (Heli‐
Coil).
♦ In the case of transmis‐
sions without threaded
inserts, bolts with
strength category 8.8 are
to be used.
♦ Bolts with strength cate‐
gory 8.8 are listed in the,
refer to the electronic
parts catalog ETKA to
VIN 8J-7-050 000.
♦ Bolts with strength cate‐
gory 10.9 are listed in the,
refer to the electronic
parts catalog ETKA from
VIN 8J-8-000 001.
♦ The bolt tightening spec‐
ification corresponds to
the strength category.
• Transmission with threaded inserts in connection with bolts of strength category 10.9:
❑ 50 Nm plus an additional 90° turn
• Transmission without threaded inserts and bolts with strength category 8.8:
❑ Always replace
❑ 40 Nm plus an additional 90° turn
3 - Engine Support
4 - Bolt
❑ Engine support to engine
❑ Tightening specification, refer to ⇒ Engine Mechanical; Rep. Gr. 10 ; Description and Operation
5 - Engine Mount
6 - Bolt
❑ Engine mount to body
❑ Tightening specification, refer to ⇒ Engine Mechanical; Rep. Gr. 10 ; Description and Operation
7 - Connecting Bar
8 - Bolt
❑ Connecting bar to engine
❑ Tightening specification, refer to ⇒ Engine Mechanical; Rep. Gr. 10 ; Description and Operation
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Manual Transmission - Edition 10.2009
2. Description and Operation
Audi TT 2007 ➤
73