Audi TT 2007 Repair Manual page 146

Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
– Install circlip -1- for grooved ball bearing/input shaft.
– Remove -30 - 211 A- for input shaft.
– If lock sleeve for selector shaft has been removed, drive it in
now using -T10169- until tool makes contact.
– Turn transmission with opening for selector shaft in assembly
stand upward.
– Insert selector shaft -1- into lower mounting -2- and into shift
forks -3-.
Note
To improve clarity, the cap is removed.
– Now press selector shaft -1- against lock sleeve -2- in direction
of -arrow- and guide downward with shift finger -3- through
shift forks until stop.
• Shift cover -4- must stand parallel to bolting surface on trans‐
mission housing during this.
• Selector shaft must be able to be moved easily in selector
motion (up- and downward).
Note
If shift cover stands at an angle to bolting surface, selector shaft
is not inserted in lower bearing.
140
Rep. Gr.34 - Controls, Housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.